| |
 |
 |
 |
|
Very good, but incomplete |
May 5, 2020 |
| Reviewer:
Brian K from Los Angeles, CA United States
|
|
Used on 1974 Elite 502. This harness is well made and seemingly made from good quality materials. It fits relatively well, and comes with a bag of single sleeve snap connectors.
I ran into a few small snags:
- two wires going to the fusebox were 6.5" shorter than the others - I ended up having to make extensions.
- a voltage regulator connector is not included. In its place are snap connectors so that you can re-use the old regulator connector.
- my car wanted a bullet connector for the voltage regulator feed from the alternator, but the harness came with a spade.
- the insulation around the thermostat plugs was too thick and had to be cut down.
To complete the project, I needed:
- 4 x Double Sleeve (C312)
- 2 x Isolated Triple Sleeve (C333)
- 12 x Bullet for 14 Strand PVC Wire (C314)
- 2 x Single sleeve (included)
In summary, this is a well made harness, but is incomplete and needs modification (as noted above). Well worth the money, despite the small issues.
Was this review helpful to you? 
|
|
 |
|
 |
|
